Home › Forums › RV-C Technical Forum

Network Power Ampacity Clarification

Tue, 2008-10-21 16:25 — Anonymous

I'm sure it's just a typo, but "Section 9 Network Power" subsection "c" states:

c) Maximum current per conductor over network trunk cable according to wire gauge and network bus length shall not exceed specifications in table 9.1 and shall comply with “ANSI/RVIA Standard for Low Voltage Systems in Conversion and Recreational Vehicles[1]”.

Which is just fine, except there is no table 9.1 in the existing spec.
So, I'm assuming I can use normal wire ampacity tables?

Regards,

‹ Message timing restrictions Physical Media Questions (Wiring and Cable) ›
Thu, 2008-11-20 22:49 — Martin Perlot

Frankly, I think the text

Frankly, I think the text should be expunged. Compliance with ANSI standards is implicit in being installed in an RV.

Thu, 2021-01-21 21:39 — Martin Perlot

I entirely agree. Let's

I entirely agree. Let's consider this a formal proposal to remove the indicated verbiage.